About Us
Peeling trim, faded siding, and water stains make a home look tired and they let moisture in if you wait too long. We handle this with tight prep, pro paints, and clean lines as your interior house painter, exterior house painter, and roof painter in Otago, and Otago House Painters gets it done with careful planning so the finish lasts.
We are Otago House Painters in Otago, and our crew has years of hands-on painting and problem solving in local homes and small buildings. We stand out for deep prep, moisture checks, careful masking, tidy sites, daily updates, and a clear written plan that we follow.
You get a finish that holds up because we wash, treat mildew, scrape, sand, prime the right way, and apply true two coat systems at the right spread rate. We show up when we say we will, protect floors and landscaping, use low odour paint indoors so you can get back to normal fast, and we back the work with a written workmanship warranty.
Interior work covers drywall repair, sanding, caulking, priming, and two smooth coats on walls, ceilings, trim, and cabinets with low odour paints so rooms look sharp and you get back to normal fast, while exterior work includes pressure washing, scraping, sanding, spot prime, full caulk, and the right application method with brush, roll, or spray and back roll so the paint film builds right and seals out weather. As your roof painter we clean and treat rust on metal, coat tile or shingles where it makes sense, test adhesion, and use safety harnesses, and we guide you on timing such as repainting exteriors every five to ten years and busy interiors every three to five years or sooner if you see peeling, hairline cracks, water stains, or chalky colour, because skipping prep or painting in the wrong weather leads to early peeling, blistering, mildew, and costly wood or drywall repair.
Our roof painter work focuses on safe access, rust treatment, and reflective or waterproof roof coatings for metal or tile roofs to cut heat and extend roof life. We never paint over mildew, skip primer on glossy or chalky surfaces, or paint in direct midday sun because those shortcuts cause flashing, blistering, and early failure.
